HOPEDAMAI Floor lamp Shelves Installation Guide

Welcome to choose HOPEDAMAI floor lamp shelf. Please read this installation guide carefully before use. Here you can get detailed installation guidelines and installation precautions.

Shelf Floor Lamp With Remove Control installation

Attention: Please strictly follow the installation sequence below, otherwise the installation will be unsuccessful and the lighting sequence will be confused.

Step 1:Package List Check

Please note that the quantity ofparts may vary based on the model. Refer to the providedpackage list for an accurate count.Attention: Please pay special attention to distinguishing between Tube A, B, and C

Step 2:Assembling the Shelves

Take the installation ofa Square 4 Tier floor lamp with shelves as an example.

Attention: Begin assembling the shelves by following sequence:shelf4->shelf3->shelf2->shelf1

This sequence is crucial for the proper functioning ofthe floor lamp When installing each shelf, make sure each shelfis oriented in the same direction.If the shelves are not oriented in the same direction, the shelves andstainless steel tubes may become deformed, making the installationunsuccessful. Different directions ofthe shelves will also cause thelights to not light up.

Step 01: Locate shelf 4 and placeit on the floor with the side markedwith number facing upwards, thenloosen the nuts counterclockwise.

Step 02: Locate Tube C,insert theunthreaded end of the Tube Cinto the nut, and then tighten thenuts clockwise.

Step 03: Locate Shelf 3, loosen thenuts, and thread it through Tube C.making sure it remains level beforetightening the nuts.

Step 04: Locate Tube B and connect theInternal threaded end of Tube B toTube C.

Step 05: Locate Shelf 2, loosen thenuts, and thread it through Tube B,making sure it remains level beforetightening the nuts.

Step 06: Locate Tube A and connect theInternal threaded end of Tube A toTube B.

Step 07: Locate Shelf 1, loosen thenuts, and thread it through Tube A,making sure it remains level beforetightening the nuts.

Step 08: Locate leveling feet and screwthem into the holes of Tube A.

Step 09: Flip the floor lamp 180 degrees.

Step10: Plug power into the powersocket on Shelf 1.

Step11: Secure the anti-tip bracket toShelf4 and place the foor lamp in thedesired location. Drive screws throughthe bracket and into the wall to securethe floor lamp to the wall.

1.Long press the button  to turn on the light. 

2.Quickly double tap the button  to change the color temperature (switch between white.neutral and warm light)

3. Long press the button  again to turn off the light.

1. Long press the button   to open the RGB light.

2. Quickly double tap the button  to switch to different dazzling color effects.

3. long press the button  to close the RGB light.

For more detailed installation tutorials, please click on the corresponding product installation video to watch！